ASTG – AirBreather System

October 5, 2024 Written by lesley@webjunky.co.za

AirBreather Systems™ was developed by ASTG at the request of one of the world’s largest gas manufacturers looking to update their gas purity verification system. 5 years of development, that included 2 years of field trials and 1 year of in-service validation, AirBreather Systems™ was born. A robust, economical, maintenance friendly system, incorporating state-of-the-art technology and proprietary software to provide fast, accurate, readily accessible gas purity verification.

Read More

ASTG – 5000 Series Portable Gas Purity Tester

September 20, 2024 Written by lesley@webjunky.co.za

ASTG Model 5000 – Portable Gas Purity Monitoring System provides continuous gas purity measurements based on the physical properties of gases present. Gas purity is determined by measuring the speed of sound in a resonant acoustic cell, alongside temperature in the gas mixture and knowledge of thermodynamic properties and molar mass.

Read More

PTI-CCIT – Vacuum Decay

August 21, 2024 Written by lesley@webjunky.co.za

Vacuum decay is a container integrity test method taking advantage of the fundamental physical properties. This test method which was proved over decades has been improved with the advancement of technology.

Read More

PTI-CCIT – Seal Quality Inspection

August 21, 2024 Written by lesley@webjunky.co.za

Seal Quality Inspection with Airborne Ultrasound Technology
Airborne ultrasound is a referenced technology in the new USP <1207> Chapter Guidance as a deterministic test method for seal quality testing, is an ASTM Test Method F3004 and FDA Recognized Standard for seal quality integrity testing.

Read More

METOP – Non-Destructive Can Seam Analysis

August 21, 2024 Written by lesley@webjunky.co.za

The non-destructive X-ray evaluation method measures parameters with an x-ray resulting
in highly accurate measurements and no need for cutting the can open to make internal
measurements. Metop’s new X-ray system, 700X uniquely measures all external and internal
parameters, including can height and countersink depth, in one operation

Read More

TecSense – TecPen

August 21, 2024 Written by lesley@webjunky.co.za

TecPen Fluid is a hand-held sensor system for determining the residual
oxygen content in beverages such as beer, wine or soft drinks. It is attached
directly to a sample outlet and rinsed with the beverage and measures
thereby the residual oxygen content.

Read More

Hengesbach – Pressure Monitoring PZM

August 21, 2024 Written by lesley@webjunky.co.za

The PZM050D pressure transmitter is suitable for measuring the pressure and filling level, fulfilling the basic requirements of exactness. The robust stainless steel field housing in the hygienic design and the checked protection classes IP 67 and IP 69K withstand all aggressive and residue-free cleaning procedures such as those required in the food industry.

Read More

ENDUSER SYSTEMS – Burst/Collapsible Bottle Solution

August 21, 2024 Written by lesley@webjunky.co.za

Typically, in glass bottle filler lines, an actual glass bottle, or only a signal test is used to simulate a bottle burst scenario. This results in poor testing, production delay and risk of glass fragments in the process.
The idea was to design and build a reusable test bottle, that can be applied during normal burst test procedures, risk-free and without stopping the line.

Read More